Request information
Home  |  Insulation  |  Fiberglass

Fiberglass Duct Liner and Board

Fiberglass Duct Liner and Duct Liner Board enhances indoor environmental quality by absorbing noise within sheet metal ducts. The product also contributes to indoor comfort by lowering heat loss or gain through duct walls.

Fiberglas® Duct Liner Board by Owens Corning

Fiberglas® Duct Liner Board by Owens Corning

Fiberglas® Duct Liner Board from Owens Corning is a bonded board of glass fibers designed to be installed inside sheet metal ductwork or plenum with metal fasteners and adhesives. The smooth, fire-resistant airstream surfaces resist damage during installation and in service.

Fiberglas® Duct Liner Board complies with the requirements of National Fire Protection Association Standards NFPA 90A and 90B, qualifying them under other model codes. It is ideal for use in large ducts and plenum where air velocities do not exceed 6,000 fpm (30.5 m/s). The black mat facing of Fiberglas® Duct Liner Board provides a smooth, durable surface making it easy to clean.

Mat-Faced Micro-Aire® Duct Board by Johns Manville

Mat-Faced Micro-Aire® Duct Board by Johns Manville

Mat-Faced Micro-Aire Duct Board from Johns Manville is produced from durable glass fibers, bonded with a thermosetting resin. The airstream side of Mat-Faced Micro-Aire® Duct Board features a fiber glass mat for use at velocities up to 5,000 fpm (25.4 m/sec). The opposite side features a fire-resistant Foil-Scrim-Kraft facing extending the full width of the male edge to serve as an integral closure flap for section joints.

Mat-Faced Micro-Aire® Duct Board is molded with double-density, male/female edges for secure connections. It is ideal for fabrication into rectangular ductwork for use in heating, ventilating, and air conditioning systems in new commercial or residential construction, or for renovating older sheet metal systems.

QuietR™ Acoustic Duct Liner by Owens Corning

QuietR™ Acoustic Duct Liner by Owens Corning

QuietR™ Acoustic Duct Liner from Owens Corning is a bonded blanket of glass fibers designed to be installed inside sheet metal ductwork and plenums with metal fasteners and adhesives. The smooth, fire-resistant airstream surfaces resist damage during installation and in service. QuietR™ Acoustic Duct Liner complies with Requirements of National Fire Protection Association Standards NFPA 90A and 90B, qualifying it under other model codes.

QuietR™ Acoustic Duct Liner is available in a selection of densities and thicknesses to meet specific system thermal and acoustical performance requirements.Rolls are sized to run efficiently on modern automatic coil lines.

QuietR™ Acoustic Duct Liner has a tough, flame-retardant airstream surface with an EPA registered biocide that stands up to gouging and other abuse in the shop and on the way to the job-site. It also contributes to reliable long-term service at internal air velocities up to 6,000 fpm (30.5 m/s).